You can set the time to wait before sending the next ICMP Echo Request message using the parameter time. Specifies the time to wait before sending the next ICMP Echo Request message.Įach time the source sends an ICMP Echo Request message using the ping command, the source waits a period of time (500 ms by default) before sending the next ICMP Echo Request message. In the case of the broadcast links (on the Ethernet), the destination address is the next hop address of the ICMP Echo Request message. This process prevents ping failures caused by incorrect routing entries. If you have specified this parameter, the device no longer searches the routing table before sending ICMP Echo Response packets. Specifies an IP address for the next hop. The value is an integer that ranges from 1 to 255. If the TTL field is reduced to 0 during message forwarding, the Layer 3 device that the message reaches sends an ICMP timeout message to the source host, indicating that the destination host is unreachable. Indicates that packets are not fragmented during transmission. The value is an integer that ranges from 0 to 63.
Indicates that the socket works in debug mode.īy default, the socket works in non-debug mode. The value is an integer that ranges from 1 to 4294967295. In the case of poor network quality, you can set this parameter to a comparatively large value to check the network quality based on the packet loss rate. You can set the number of ICMP Echo Request messages to send by specifying the parameter count. By default, five ICMP Echo Request messages are sent. The ping command labels each ICMP Echo Request message with a sequence ID that starts from 1 and is increased by 1. Specifies the number of times for sending ICMP Echo Request messages. If no source IP address is specified, the IP address of the outbound interface is used as the source IP address of ICMP Echo Request messages. Specifies the source IP address of ICMP Echo Request messages. The value is an integer that ranges from 0 to 7. Specifies the 802.1p priority in VLAN packets. If ip is not specified, the IPv4 protocol is used.
0 kommentar(er)
